 |
RAM-TRIPOD1-HC1U shown above.
RAM-TRIPOD1-HC1U Includes the Following:
- Warranty: Manufacturer's, RAM Mounts (National
Products Inc.), Limited Life Time Warranty.
- Bubble Level: Built in bubble level and comfortable grips make setup and handling a breeze.
- Carrying Case: A carrying case is included to house the RAM-TRIPOD1.
- Dimensions: Three piece telescoping legs with quick release allow the legs to be independently adjusted for uneven surfaces. The tripod adjusts to following heights:
- Minimum Tripod Height: 21 inches (without Handi-Case)
- Maximum Tripod Height: 58 inches (without Handi-Case)
- Hardware Included: Yes. Dual sided threaded screw with 3/8"-16 male and 1/4"-20 male thread attaches to the tripod center column. This can be used to secure cameras and other accessories.
- RAM-202CNSU: Single 2.5 inch diameter mount with 3/8"-16 female hole and 1.5 inch diameter rubber ball. This
mount attaches to the supplied 3/8"-16 male thread on top of the RAM-TRIPOD-1.
- RAM-201U: Double socket arm allows a 1.5 inch diameter ball accessory to be connected at
either end. A tightening knob on the side of the arm enables the sockets to
clamp firmly to the attached accessories. The arm allows for easy adjustment by
loosening the side knob, a single spring inside the arm opens the sockets,
allowing the arm to pivot on the attached accessory. This enables the arm
and accessories to be positioned at various angles allowing the ultimate in
position flexibility. Loosen the knob completely and the arm will disconnect
from the accessories in seconds!
- Arm Material: Black powder coated marine grade aluminum with plastic twist knob.
- Arm Length Socket Center to Socket Center: 4.55 inches.
- Overall Arm Length: 5.625 inches.
- RAM-202U:
2.5 inch diameter marine grade aluminum mounting plate with 1.5 inch
diameter rubber ball. The plate has pre-drilled holes included the AMPS
hole pattern. This mounting plate can be used to attach to RAM Tough
Tray and RAM electronic holders (RAM-HOL-xxxx)
- Manufacturer's Handi-Case Description: The RAM-HOL-HC1U Handi-Case is capable of doing so many tasks
it will astound you. When a brief case it too much but a note pad, is
not enough, the Handi-Case is exactly what you need. Beyond just a
writing surface, you get document storage, mouse pad, tool holder, pen
and pencil storage, and of course, RAM's rugged construction.
- Multiple mounting points on the top and bottom to attach any number of
popular RAM rubber ball bases or mounting plates for unsurpassed
versatility.
- Two convenient
mounting points on the top for a cell phone, GPS, or other small
electronics mount.
- Multiple punch outs on the sides and back, it is even possible
to run power into or out of the RAM Handi-Case.
- Multiple storage spaces inside the case to hold documents, pens, nuts, bolts, etc..
- Pockets for magnets that can be used to hold pens.
|
|
|
