RAP-B-104-224-GA7U 3.25" Dia. Pivot Suction Cup Mount for Garmin 176C, 196, 276C, 296

VEHICLE LAPTOP MOUNTS

.

Product Request
Contact Us

CLICK HERE to email for product information or a price request.

RAM Mount Help 101

CLICK HERE for RAM sizing guide and naming convention help.

Home > Suction Cup Mounts > Suction Cup Assemblies with Cradle for GPS, Smartphone & Universal Holders for Small Electronic Devices > RAP-B-104-224 Series Assemblies > Garmin Assemblies >

Single 3.25" Dia. Base with Twist Lock, Plastic Dual Pivot Arm and Garmin RAM-HOL-GA7U Holder (Selected GPSMAP 176x, 196x, 276x, 296x and 396 Series)

Price $40.99

STOCK STATUS: Out of Stock - Email for ETA

Product Code: RAP-B-104-224-GA7U

QTY:

DESCRIPTION

The RAP-B-104-224-GA7U is a universal high strength composite suction cup mount with a 3.25 inch diameter locking suction cup base and Garmin cradle. The suction cup mount consists of a 1 inch diameter ball and socket with rotating and pivoting button system and RAM plastic universal diamond plate. This device fits the following Garmin models:

Garmin GPSMAP 176

Garmin GPSMAP 176C

Garmin GPSMAP 276C

Garmin GPSMAP 376C

Garmin GPSMAP 378

Garmin GPSMAP 478

Garmin GPSMAP 196 (Aviation GPS)

Garmin GPSMAP 296 (Aviation GPS)

Garmin GPSMAP 396 (Aviation GPS)

Garmin GPSMAP 496 (Aviation GPS)

NOTE: As the manufacturer adds new units/models to the above series this cradle may fit additional models not listed above. Please call 224-578-9162 or complete the product inquiry form by clicking here.

RAP-B-104-224-GA7U shown above.

RAP-B-104-224-GA7U Includes the Following:

Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
Mount End Plate Design: The RAP-B-238 RAM Mount High Strength Plastic Composite Universal Plate has a 1.0 inch diameter rubber ball connected at right angles to a 1 1/4 x 2 1/2 inch Diamond Plate. The plate has two holes positioned at either tip of the diamond plate.
Mount Arm Design: The RAP-B-200-1 RAM Mount Socket and Octagon Button Arm includes a 1 inch B sized ball socket and is made of high strength plastic. The arm is 1.75 inches long when measured from socket center to button socket end. The side of the arm includes a tightening knob which allows you to open and close the socket ends.
Mount Base Design: The RAP-224-2 RAM Mount high strength plastic locking 3.25 inch diameter rubber suction cup base is designed to have an extra strong hold on any smooth non-porous surface. With a twist on the locking knob, the suction cup base adheres to any glass or non-porous plastic surface. Connected to the top of the RAM suction cup is a male RAM plastic octagon button with pivot connection. The pivot design allows the mount to tip from 0° to 90° to the suction cup, while the octagon button connections allows the arm to rotate 360°. The button end connects directly to a RAP-B-200-1 plastic arm with socket and female button ends.
Cradle: RAM-HOL-GA7U high strength plastic cradle is designed to hold the Garmin device specified above. The cradle has a cut away at the bottom to allow the connection of all required cables (not included). The cradle also enables full access to all buttons and port.
Optional Cradles. To view other optional cradles for Apple, cell phone or GPS units click here.