Home > Flat Surface Mounts > RAP = COMPOSITE Light Duty Mounts -1.0" B-Ball, 1.5" C-Ball & Snap Link Mounts >

COMPOSITE 2" x 2.5" Base with B Sized 1.0" Dia. Ball, SHORT Sized Length Arm and Universal 6.25 Inch x 2 Inch Plate with Pre-Drilled Holes
COMPOSITE 2" x 2.5" Base with B Sized 1.0" Dia. Ball, SHORT Sized Length Arm and Universal 6.25 Inch x 2 Inch Plate with Pre-Drilled Holes


 
Alternative Views:


Price $31.49

STOCK STATUS: In Stock - Ships Next Bus. Day


Product Code: RAP-B-111-A
QTY:

DESCRIPTION
 
**CLICK HERE for the Latest Fish Finder & Chartplotter Compatibility Guide for this Mount.**

The RAP-B-111-A is a 6.25 inch by 2 inch rectangular COMPOSITE universal mounting plate with a 2 inch X 2.5 inch base plate with 1.0 inch diameter rubber ball and SHORT sized length arm. The mounting plate can be used for many electronic devices including: CB Radios, HAM Radios, and Marine Electronics.

RAP-B-111-A shown above. Mounting hardware is not included.

NOTE: The RAP-B-111-A is also available as a marine grade assembly commonly used for marine applications.
Click here to view the marine grade assembly.

RAP-B-111-A Features Below:

  • Warranty: Manufacturer's, RAP Mounts (National Products Inc.), Limited Life Time Warranty.
  • Overall Height: 3.75 inches when positioned at full extension.
  • Mounting Plate Material: Composite with rubber ball.
  • NOTE: This plate can also be drilled into for a custom hole pattern without voiding the manufacturers warranty.
  • Mounting Plate Dimensions: 6.25 inches * 2 inches with 1.0 inch diameter "B" sized rubber ball.
  • Socket Ball Size: Connects to 1.0 inch B Ball Size
  • Mounting Plate Description: RAP-B-111-BU (RPR-B-115-RDB) has many different combination of pre-drilled holes which will match many electronic devices including: CB Radios, Ham Radios, Marine GPS and other devices.
  • Base Plate Included: RAP-B-202U-225 is a composite 2 inch x 2.5 inch rectangular plate with a 1.0 inch diameter rubber ball. The plate has pre-drilled holes at each corner.
  • Arm Included: RAP-B-201U-A is a short length composite arm 2.0 inches in length from socket center to socket center and 2.38 inches in overall length. A tightening knob on the side of the arm enables the sockets to clamp firmly to the attached base and mounting plate. The arm allows for easy adjustment by loosening the side knob, a single spring inside the arm opens the sockets, allowing the arm to pivot on the attached plates. This enables the arm and mounting plate to be positioned at various angles allowing the ultimate in position flexibility. Loosen the knob completely and the arm will disconnect from the accessories in seconds!


ACCESSORIES FOR THIS PRODUCT...
COMPOSITE Universal 2.5 Inch Round Plate with 1 Inch Ball COMPOSITE 2 Inch x 2.5 Inch Plate with 1 Inch Dia. Ball
Price: $8.99

Add
Price $8.49

Add
COMPOSITE Universal 2.5 Inch Round Plate with 1 Inch Ball COMPOSITE 2 Inch x 2.5 Inch Plate with 1 Inch Dia. Ball


Browse for more products in the same category as this item:

Flat Surface Mounts > RAP = COMPOSITE Light Duty Mounts -1.0" B-Ball, 1.5" C-Ball & Snap Link Mounts