Home > Adhesive Base Stick Mounts > RAP-SB-178 (.75 Inch Snap Link Ball and Socket Arm) Assemblies with Cradle > Lowrance Assemblies >

2.5 Inch Adhesive Flex Stick Base with Lowrance RAM-HOL-LO9U Selected Endura (Safari, Sierra, & Out&Back) Series
2.5 Inch Adhesive Flex Stick Base with Lowrance RAM-HOL-LO9U Selected Endura (Safari, Sierra, & Out&Back) Series


 

STOCK STATUS: Out of Stock - Email for ETA


Product Code: RAP-SB-178-LO9U
QTY:

DESCRIPTION
 
The RAP-SB-178-LO9U is a simple and attractive adhesive base mount designed for the following Lowrance models:
  • Lowrance Safari
  • Lowrance Sierra
  • Lowrance Out&Back

NOTE: As the manufacturer adds new units/models to the above series this cradle may fit additional models not listed above. Click here for the most current model information RAM-HOL-LO9U. Please call 224-578-9162 or complete the product inquiry form by clicking here.


RAP-SB-178-LO9U shown above.

RAP-SB-178-LO9U Includes the Following:
  • Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
  • Base Description: The base includes a 2.5 inch RAM-202PSA 3M semi-permanent adhesive disk pad that attaches firmly to a flat surface. 
  • Arm: Flexible snap link arm that allows the ultimate in versatility.
  • Adapter: Composite black powder coated universal diamond plate. Two holes measuring 1.9 inches from center to center is compatible with the AMPS hole pattern and any RAM Mount holder (RAM-HOL-xxxx) for future mounting options.
  • Cradle Description: Includes the RAM-HOL-LO9U high strength composite cradle designed to hold the GPS unit specified above. Place the top of the GPS unit into the cradle, and then push the base into the expandable arms at the bottom of the holder. The arms will then snap into place when the GPS is completely secured in the cradle. The cradle allows all cables (NOT INCLUDED) to stay connected while the GPS unit is in the cradle.
  • Optional Cradles (NOT INCLUDED): To find other cradles for Apple, cell phone or GPS holder click here.
Instructions
  • General recommendations to properly adhere the adhesive disc.
    1. Ensure that both the dashboard surface and the bottom of the Ram Mount base have been thoroughly cleaned and dried.
    2. Attach either side of adhesive to the base first, let it sit several hours to allow adhesive to thoroughly bond.
    3. Attach other side of adhesive (with base) to the dashboard surface.
    4. Let the adhesive disc sit several hours before adding socket arm components, etc. to allow the adhesive to properly bond to the dashboard surface.


Browse for more products in the same category as this item:

Adhesive Base Stick Mounts > RAP-SB-178 (.75 Inch Snap Link Ball and Socket Arm) Assemblies with Cradle > Lowrance Assemblies