Home > Adhesive Base Stick Mounts > RAP-B-378 (1 Inch Ball and Socket Arm) Assemblies with Cradle > Garmin Assemblies >

2.5 Inch Adhesive Base with Composite Standard Sized Arm and Garmin RAM-HOL-GA57U Holder (Selected nuvi 2557, 2577, 2597 Series)
2.5 Inch Adhesive Base with Composite Standard Sized Arm and Garmin RAM-HOL-GA57U Holder (Selected nuvi 2557, 2577, 2597 Series)


 
Alternative Views:

STOCK STATUS: Out of Stock - Email for ETA


Product Code: RAP-B-378-GA57U
QTY:

DESCRIPTION
 
The RAP-B-378-GA58U is a 2.5 inch diameter adhesive disk base, plastic arm, diamond adapter plate and cradle designed to fit the following devices:
  • Garmin nuvi 2557LMT
  • Garmin nuvi 2577LT
  • Garmin nuvi 2597LMT
NOTE: As the manufacturer adds new units/models to the above series this cradle may fit additional models not listed above. CLICK HERE for the most current model information or contact us by CLICKING HERE.

RAP-B-378-GA57U Includes the Following:
  • Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
  • Included Base: RAP-B-378U 2.5 inch adhesive disk base with 1 inch diameter rubber ball. Put the base practically anywhere you want to keep your handheld device easy to see and always within your reach. Designed with a very small foot print, finding a home on your dash or console is easy.
  • Included Arm: RAP-B-201U composite arm measures approximately 3.0 inches between socket center to socket center and is 3.6875 inches in total length. A tightening knob on the side of the arm enables the sockets to clamp firmly to a RAM 1 inch diameter ball. When loosening the side knob, you can pivot the ball and socket connections or completely disconnect the ball from the socket.
  • Included Adapter: RAP-B-238U Composite black powder coated universal diamond plate. Two holes measuring 1.9 inches from center to center is compatible with the AMPS hole pattern and any RAM Mount holder.
  • Cradle Description: Included RAM-HOL-GA57U high strength plastic holder for the devices specified above. Place the top of the GPS unit into the cradle, and then push the base into the expandable arms at the bottom of the holder. The arms will then snap into place when the GPS is completely secured in the cradle. The cradle allows all cables (NOT INCLUDED) to stay connected while the GPS unit is in the cradle.
  • Optional Cradle (NOT INCLUDED): Additional cradles for Apple, cell phone or GPS holders can be found by clicking here.
Instructions
  • General recommendations to properly adhere the adhesive disc.
    1. Ensure that both the dashboard surface and the bottom of the Ram Mount base have been thoroughly cleaned and dried.
    2. Attach either side of adhesive to the base first, let it sit several hours to allow adhesive to thoroughly bond.
    3. Attach other side of adhesive (with base) to the dashboard surface.
    4. Let the adhesive disc sit several hours before adding socket arm components, etc. to allow the adhesive to properly bond to the dashboard surface.


Browse for more products in the same category as this item:

Adhesive Base Stick Mounts > RAP-B-378 (1 Inch Ball and Socket Arm) Assemblies with Cradle > Garmin Assemblies