themountdepot.com

NOTE: This cradle WILL NOT FIT the 1st, 2nd, 3rd or 4th generation iPhone's.
To see all iPhone cradles click here.


RAP-B-166-2-AP11U shown above.

RAP-B-166-2-AP11U Includes the Following:

• Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
• Base: 2.7 inch locking suction cup base with 1 inch diameter rubber ball. This base has a strong hold on any smooth non-porous surface, but for best results mount the suction cup base to a glass surface.
• Arm: RAP-B-201-1U composite arm measures approximately 2.0 inches between socket center to socket center and is 2.75 inches in total length. A tightening screw on the side of the arm enables the sockets to clamp firmly to a RAM 1 inch diameter ball. When loosening the side screw, you can pivot the ball and socket connections or completely disconnect the ball from the socket. The arm length is
• Adapter: RAP-B-238U composite universal diamond plate. Two holes measuring 1.9 inches from center to center is compatible with the AMPS hole pattern and any RAM-HOL-xxxx cradle.
• Cradle: RAM-HOL-AP11U high strength plastic holder for the device(s) specified above. Place the top of the iPhone into the cradle, and then push the base into the expandable arms at the bottom of the holder. The arms will then snap into place when the iPhone is completely secured in the cradle. The cradle allows all cables (not included) to stay connected while the iPhone unit is in the cradle.

  RAP-B-166-2-AP11U Options (NOT INCLUDED):

  Optional Cradle(s): Additional cradles to secure Apple, cell phone or other GPS units can be viewed by clicking here.

  Optional Cup Holder Mounting Base: Optional RAM-299-3U cup holder base attaches to the suction cup base of the RAP-B-166-2U. This allows you to mount your device in the cup holder of your vehicle! Perfect for those who do not want to mount to the windshield.