Home > Aviation and Yoke Mounts > Aviation Assemblies with Cradle (Apple, Garmin, GPS, Smartphone, Tablet, Universal, etc.) > Apple Assemblies by Device Type (iPad, iPhone, iPod Touch, etc) >

Single 3.25" Dia. Base with Twist Lock, Plastic Dual Pivot Arm and Apple RAM-HOL-AP7U Holder (iPod Touch 2nd & 3rd Gen WITHOUT Case or Cover)
Single 3.25" Dia. Base with Twist Lock, Plastic Dual Pivot Arm and Apple RAM-HOL-AP7U Holder (iPod Touch 2nd & 3rd Gen WITHOUT Case or Cover)


 

STOCK STATUS: Out of Stock - Email for ETA


Product Code: RAP-B-104-224-AP7U
QTY:

DESCRIPTION
 
The RAP-B-104-224-AP7U is a universal high strength composite suction cup mount with a 3.25 inch diameter locking suction cup base and Apple iPod Touch (2nd and 3rd Generation Holder). The suction cup mount consists of a 1 inch diameter ball and socket with rotating and pivoting button system and RAM plastic universal diamond plate.

NOTE: The RAP-B-104-224-AP7U WILL NOT FIT the 1st generation Apple iTouch Models. To view all Apple iTouch model assemblies click here.


RAP-B-104-224-AP7U shown above.

RAP-B-104-224-AP7U Includes the Following:

  • Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.

  • Mount End Plate Design: The RAP-B-238 RAM Mount High Strength Plastic Composite Universal Plate has a 1.0 inch diameter rubber ball connected at right angles to a 1 1/4 x 2 1/2 inch Diamond Plate. The plate has two holes positioned at either tip of the diamond plate.

  • Mount Arm Design: The RAP-B-200-1 RAM Mount Socket and Octagon Button Arm includes a 1 inch B sized ball socket and is made of high strength plastic. The arm is 1.75 inches long when measured from socket center to button socket end. The side of the arm includes a tightening knob which allows you to open and close the socket ends.

  • Mount Base Design: The RAP-224-2 RAM Mount high strength plastic locking 3.25 inch diameter rubber suction cup base is designed to have an extra strong hold on any smooth non-porous surface. With a twist on the locking knob, the suction cup base adheres to any glass or non-porous plastic surface. Connected to the top of the RAM suction cup is a male RAM plastic octagon button with pivot connection. The pivot design allows the mount to tip from 0° to 90° to the suction cup, while the octagon button connections allows the arm to rotate 360°. The button end connects directly to a RAP-B-200-1 plastic arm with socket and female button ends.

  • Cradle: RAM-HOL-AP7U high strength plastic cradle is designed to hold the 2nd and 3rd generation Apple iPod Touch series. The cradle has a cut away at the bottom to allow the connection of all required cables. The cradle also enables full access to the volume and mute button on the side along with the power button and headphones jack at the top of the iPod Touch. When mounting the iPod Touch cradle to a RAM Mount with their patented ball and socket system, you can easily display your iPod Touch in landscape or portrait view.

  • Optional Cradles. To view other optional cradles for Apple, cell phone or GPS units click here.

NOTE: This mount does not require any drilling for installation


Browse for more products in the same category as this item:

Aviation and Yoke Mounts > Aviation Assemblies with Cradle (Apple, Garmin, GPS, Smartphone, Tablet, Universal, etc.) > Apple Assemblies by Device Type (iPad, iPhone, iPod Touch, etc)
iPod Touch > iPod Touch (2nd & 3rd Gen) Assemblies