| The RAM-B-279U rubber weighted dash base with 1 inch ball. The RAM-B-279U has a non-skid
rubber coated lead base. The lead core allows you to shape the base to
your dash, with a sticky underside to stop it from sliding. No fastening is required for the RAM-B-279U. This base can
be used for cell phones, GPS, iPod, and other electronic devices when
purchased with an arm and holder.
The RAM-B-279U most popular options are the RAM-B-201U standard length arm and RAM-B-238U Universal Diamond Plate that will connect to any RAM Holder/Cradle (RAM-HOL-xxxx). Select a holder for Apple, cell phones and GPS systems by clicking here. For more information on the optional RAM-B-201U arm and RAM-B-238U diamond plate (not included) read below:
The
RAM-B-201 double socket arm has a socket at either end to allow a
1 inch diameter ball accessories to be connected. A tightening screw on
the
side of the arm enables the sockets to clamp firmly to a RAM 1 inch
diameter ball. When loosening the side screw, a single spring inside
the arm opens the sockets allowing you to pivot the ball and socket
connection or completely disconnect the ball from the socket. The arm
length is 3.0 inches when measured from socket center to socket center.
The total length of the arm is 3.69 inches.
The RAM-B-238 has
a 1.0 inch diameter rubber ball connected to the 1 1/4 x 2
1/2 inch diamond plate. The diamond plate has two holes positioned 1.9
inches from center to center. The hole pattern found on the diamond
plate will connect to a large variety of third party cradles/holders
and RAM cradles/holders including those with the industry standard
AMPS hole pattern. NOTE: This base plate will attach to any of the RAM plastic holder/cradle (RAM-HOL-xxxx)and the industry standard AMPS hole pattern.
 |
