themountdepot.com

RAM-B-138-339-UN4U Includes the Following:

   

• Base: RAM-B-202U 2.5 inch diameter black powder coated marine grade aluminum base with pre-drilled holes and 1 inch diameter rubber ball. The pre-drilled holes accommodate the AMPS hole pattern. 
• Arm: RAM-B-201U standard length arm for 1 inch balls. The arm measures 2.875 inches between socket centers (3.6875 inches in overall length). A plastic twist knob allows you to articulate the arm in any direction.
• Adapter: RAM-B-238U universal diamond plate with two holes measuring 1.9 inches from hole center to hole center and accommodate the AMPS hole pattern.
• Holder/Cradle: RAM-HOL-UN4U High strength composite finger gripping device electronics holder is designed to hold a large amount of different kinds of cell phones (Blackberry and iPhone, etc.) and electronic devices such as GPS (Garmin E-trex, Nuvi) and MP3 players.  This is a popular holder for ATVs and motorcycles. The RAM-HOL-UN4U has four rubber coated finger placed along the side of the cradle that grips any electrical device you need to hold.  The bottom of the cradle has a plate that provides additional support to the electronic device being held.
  • Universal cradles RAM-HOL-UN1U (Small), RAM-HOL-UN2U (Medium) and RAM-HOL-UN3U Large are also available.
• RAM-HOL-UN4U Universal Cradle Dimensions Below:

• Using Short Arm Side Clamps
  • Maximum Depth: 0.75"
  • Minimum Width: 1.25"
  • Maximum Width: 3.0"
• Using Medium Arm Side Clamps
  • Maximum Depth: 1.25"
  • Minimum Width: 1.5"
  • Maximum Width: 3.5"
• Using Long Arm Side Clamps
  • Maximum Depth: 1.6"
  • Minimum Width: 2.25"
  • Maximum Width: 3.5"

RAM-202PSA Option (NOT INCLUDED): The RAM-202PSA shown below is a double sided 2.5 inch diameter 3M adhesive pad that can be placed on any flat surface. The RAM-B-202 base can then be attached to the adhesive pad without requiring drilling into the flat surface.