The RAM-101U is a C sized 1.5 inch ball flat surface marine grade aluminum mount that has two 2.5 inch diameter plates with pre-drilled holes (hardware not included) and standard sized length arm. This mount DOES NOT INCLUDE a cradle or holder. See below for cradle and holder options.
RAM-101U shown above. Mounting hardware not included.
RAM-101U Includes the Following:
- Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
- Color/Material: Black power coated marine grade aluminum.
- Socket Ball Size: C-Ball Size = 1.5 inch Ball. Maximum suggested weight 10 lbs. To see additional Ball Size options that accommodate heavier weight please see additional options listed below.
- Base Plate: RAM-202U 2.5 inch diameter base with pre-drilled holes and 1.5 inch diameter rubber ball. The pre-drilled holes accommodate the AMPS hole pattern.
- Arm: RAM-201U standard length arm for 1.5 inch balls. The arm measures 4.55 inches between socket centers (5.625 inches in overall length). A plastic twist knob allows you to articulate the arm in any direction. A shorter arm RAM-201U-B, 2.25 inches from socket center to socket center (3.5 inches in overall length), is available. Please see RAM-101U-B for the complete assembly. A longer arm RAM-201U-D, 8.75 inches from socket center to socket center (9.125 inches in overall length) is available. Please see RAM-101U-D for the complete assembly.
- Adapter Plate: RAM-202U 2.5 inch diameter base with pre-drilled holes and 1.5 inch diameter rubber ball. The pre-drilled holes accommodate the AMPS hole pattern.
- Overall Length: 7.35 inches at maximum extension and the mount is collapsible.
- Hardware Included: No. Mounting hardware is not included.
- Cradle/Holders/Aqua Box:
Optional. Select a holder for Apple, cell phones, GPS and electronic devices by clicking here.
RAM-202U Description: Black powder coated marine grade aluminum flat surface base with pre-drilled holes including AMPS hole pattern.
RAM-201U Description: Black powder coated marine grade aluminum arm allows a 1 inch diameter ball accessory to be connected at either end. A tightening knob on the side of the arm enables the sockets to clamp firmly to the attached accessories. The arm allows for easy adjustment by loosening the side knob, a single spring inside the arm opens the sockets, allowing the arm to pivot on the attached accessory. This enables the arm and accessories to be positioned at various angles allowing the ultimate in position flexibility. Loosen the knob completely and the arm will disconnect from the accessories.
RAM-201U Options (Not Included): The RAM-KNOB5LU shown below is a keyed lock and replaces the twist knob found on the RAM-201 series arm.
